HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
6
Adjusting the Ribbon Type ___________________________________________________________ 176
Adjusting the Film Type _____________________________________________________________ 178
Using the Dual Sided Group Functions _________________________________________________ 179
Using the Dual Sided - Print Both Sides option ___________________________________________ 180
Using the Print Both Sides - Split 1 Set of Ribbon panels option ______________________________ 181
Using the Print Both Sides - Print Back Image on Front of Card option ________________________ 182
Using the Dual Sided - Print Back Side Only option _______________________________________ 183
Using the Device Options Group ______________________________________________________ 184
Using the Rotate Front 180 Degrees or Rotate Back 180 Degrees options _______________________ 184
Using the Disable Printing option ______________________________________________________ 185
Using the Image Color tab (HDPii) ______________________________________________________ 186
Using the Quality – Color Matching dropdown ___________________________________________ 188
Adjusting for the Resin Dither ________________________________________________________ 191
Using the Advanced Image Color window _______________________________________________ 192
Using the Default button on the Image Color tab __________________________________________ 196
Using the Image Transfer tab ___________________________________________________________ 198
Adjusting the Image Position controls __________________________________________________ 198
Adjusting the Transfer Dwell Time and Temperature ______________________________________ 200
Conducting the Tape Adhesion Test ____________________________________________________ 203
Using the Default button _____________________________________________________________ 205
Using the Magnetic Encoding tab ________________________________________________________ 207
Using the Encoding Mode dropdown list ________________________________________________ 208
Selecting the Coercivity/Magnetic Track ________________________________________________ 212
Reviewing the Magnetic Track Options _________________________________________________ 213
Using the Character Size buttons ______________________________________________________ 214
Using the ASCII Offset dropdown list __________________________________________________ 215
Using the Bit Density dropdown list ____________________________________________________ 215
Using the LRC Generation dropdown list ________________________________________________ 216
Using the Character Parity dropdown list ________________________________________________ 217
Reviewing the ISO Track Locations ____________________________________________________ 218
Sending the Track Information ________________________________________________________ 218
Reviewing the Sample String _________________________________________________________ 219
Reviewing the ASCII Code and Character Table __________________________________________ 220
Using the Default button (Image Transfer tab) ____________________________________________ 221
Using the K panel Resin tab ____________________________________________________________ 222
Using the Scroll controls _____________________________________________________________ 223
Using the Click and Drag capability ____________________________________________________ 224
Selecting “inches or mm” radio button __________________________________________________ 224
Using the Add and Delete buttons _____________________________________________________ 225
Selecting the Full Card ______________________________________________________________ 225
Selecting the Defined Area(s) _________________________________________________________ 226
Selecting the Undefined Area(s) _______________________________________________________ 227
Defining the Area to activate the Card Grid ______________________________________________ 228
Measuring the Total Card area ________________________________________________________ 229
Measuring the Area to be positioned on the Card __________________________________________ 230
Selecting the Print YMC under the K and Print K Only options ______________________________ 231
Using the Printer Supplies tab ___________________________________________________________ 233
Reviewing Information on the Supplies tab ______________________________________________ 233
Section 8: Using the Inhibit Panel (HDPii) ________________________________________ 235
Using Inhibit Panel (via the Fargo Workbench Printer Utility) _______________________________ 235
Using Inhibit Panel (from an Application) _________________________________________________ 236
Generating TextOut Commands _______________________________________________________ 236
Rendering Print Jobs ________________________________________________________________ 237
Using the Test Print ________________________________________________________________ 243
Inhibit Panel Feature Operation _________________________________________________________ 244
To Next Page
Loading...
