switch “ ” (down) to retract the trim
rods. NOTICE: Make sure that the
trim rods retracts completely during
mooring. This protects the rods from
marine growth and corrosion, which
could damage the power trim and tilt
mechanism. [ECM00252]
HD30192
Procedure for tilting down (manual
tilt models)
1. Place the tilt lock lever in the lock posi-
tion.
free.
2. Pull out the tilt support knob.
3. Push the power tilt switch “ ” (down) to
lower the outboard motor to the desired
position.
DN
2. Slightly tilt the engine up until the tilt
sup- port bar is automatically released.
ZMU01936
DN
3. Slowly tilt the engine down.
HD33121
Procedure for tilting down (power tilt
models)
1. Push the power tilt switch “ ” (up) until
the outboard motor is supported by the
tilt rod and the tilt support knob
becomes
ZMU05581
To Next Page
Loading...
Need help?
General
