Hidea F15 - Warming up Engine; Manual Start and Electric Start; Models; Checks after Engine Warm up

WARNING
Operation
gine stops.
 Confirm that removing the clip
from the en- gine shut-off switch stops the
engine.
 Confirm that the engine cannot be
started with the clip removed from the
engine shut-off switch.
HD34561
EWM00180
Shifting
HD27670
Warming up engine
HD27716
Manual start and electric start
models
1. After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2. Be sure the low oil pressure-alert
indica- tor goes off after starting the
engine. NOTICE: If the low oil
pressure-alert indicator blinks after
the engine starts, stop the engine.
Otherwise, serious engine damage
could occur. Check the oil level and
add engine oil if necessary. Consult
your Hidea dealer if the cause for the
low oil pressure alert cannot be
found.
[ECM01831] HD36531
Checks after engine warm up
HD36541
Shifting
While the boat is tightly moored, and
without applying throttle, confirm that the
engine shifts smoothly into forward and
reverse, and back to neutral.
HD36980
Stop switches
 Turn the
main switch to “ ”, or press
the engine stop button and make sure the
en-
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01610
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
1. Pull the neutral interlock trigger up (if
equipped).
1. Neutral interlock trigger
2. Move the remote control lever / gear
shift lever firmly and crisply forward (for
forward gear) or backward (for reverse