N
ZMU05533
HD31742
EWM01510
Stopping boat
Do not use the reverse
function to slow down or stop the boat
as it could cause you to lose control,
be ejected, or im- pact the steering
wheel or other parts of the boat. This
could increase the risk of serious
injury. It could also damage the shift
mechanism.
Do not shift into reverse while
traveling at planing speeds. Loss of
control, boat swamping, or damage to
the boat could occur.
The boat is not equipped with a separate
braking system. Water resistance stops it
af- ter the throttle lever is moved back to
idle. The stopping distance varies
depending on gross weight, water surface
conditions, and wind direction.
HD27821
2. After stopping the engine, disconnect
the fuel hose from the fuel joint on the
outboard motor by turning it counter-
clockwise.
1
Stopping engine
Before stopping the engine, first let it cool
off for a few minutes at idle or low speed.
Stop- ping the engine immediately after
operating at high speed is not
recommended.
HD43190
Procedure
1. Push and hold the engine stop button
or turn the main switch to “ ” (off).
1. Fuel joint
2. Fuel hose
3. Install the fuel joint cap on the outboard
motor.
To Next Page
Loading...
Need help?
General
