When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
HD25995
Engine shut-off cord (lanyard) and
clip
The clip must be attached to the engine
shut- off switch for the engine to run. The
cord should be attached to a secure place
on the operator’s clothing, or arm or leg.
Should the operator fall overboard or leave
the helm, the cord will pull out the clip,
stopping ignition to the engine. This will
prevent the boat from running away under
power. WARNING! At- tach the engine
shut-off cord to a secure place on your
clothing, or your arm or leg while
operating. Do not attach the cord to
clothing that could tear loose. Do not
route the cord where it could become
en- tangled, preventing it from
functioning. Avoid accidentally pulling
the cord dur- ing normal operation. Loss
of engine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly. This
could cause people and objects in the
boat to be thrown forward. [EWM00122]
1. Cord
2. Clip
3. Engine shut-off switch
1. Cord
2. Clip
3. Engine shut-off switch
HD26003
Engine stop button
The engine stop button stops the engine
when the button is pushed.
To Next Page
Loading...
Need help?
General
