retor or the fogging hole of the silencer
cover, if equipped. When properly
done, the engine will smoke
excessively and almost stall.
11. Remove the outboard motor from the
test tank. For further details, see page
67.
12. Drain the cooling water completely out
of the motor. Clean the body
thoroughly.
13. Install the silencer cover/cap and top
cowling.
HD28402
Lubrication
1. Install the spark plug(s) and torque to
proper specification. For information on
spark plug installation, see page 77.
2. Change the gear oil. For instructions,
see page 82. Inspect the oil for the
pres- ence of water that indicates a
leaky seal. Seal replacement should be
performed by an authorized Hidea
dealer prior to use.
3. Grease all grease fittings. For further
de- tails, see page 76.
TIP:
For long-term storage, fogging the engine
with oil is recommended. Contact your
Hidea dealer for information about fogging
oil and procedures for your engine.
HD28423
Cleaning and anticorrosion
measures
1. Wash down the exterior of the outboard
motor with fresh water and dry off com-
pletely. NOTICE: Do not spray water
into the air intake.
2. Spray the outboard motor exterior with
“Hidea Silicone Protectant”.
3. Wax the cowling with a non-abrasive
wax such as “Hidea Silicone Wax”.
HD28445
Flushing power unit
Perform this procedure right after operation
for the most thorough flushing.
ECM01530
NOTICE
Do not perform this procedure while the
engine is running. The water pump may
be damaged and severe damage from
overheating can result.
1. After shutting off the engine, unscrew
the garden hose connector from the fit-
ting on the bottom cowling.
1. Fitting
2. Garden hose connector
3. Garden hose adapter
2. Screw the garden hose adapter onto a
garden hose, which is connected to a
fresh water supply, and then connect it
to the garden hose connector.
70
To Next Page
Loading...
Need help?
General
