HD26902
Installation
3. Hold the handgrips and steering brack-
ets as shown in the illustration and lift
up
The information presented in this section is
intended as reference only. It is not
possible to provide complete instructions for
every possible boat and motor combination.
Proper mounting depends in part on
experience and the specific boat and motor
combination.
EWM01590
the outboard motor using two people.
Overpowering a boat could
cause se- vere instability. Do not
install an out- board motor with more
horsepower than the maximum rating
on the capac- ity plate of the boat. If
the boat does not have a capacity
plate, consult the boat manufacturer.
Improper mounting of the
outboard mo- tor could result in
hazardous condi- tions such as poor
handling, loss of control, or fire
hazards. For permanent- ly mounted
models, your dealer or oth- er person
experienced in proper rigging should
mount the motor.
HD32011
Mounting the outboard motor
1. Be sure to mount the outboard motor
while the boat is on land. If the boat is
on the water, move it to an area on
land.
2. To prevent steering movement, turn the
adjuster lever to “A”.
1. Steering bracket
2. Handgrip
ZMU05634
4. Mount the outboard motor on the center
To Next Page
Loading...
Need help?
General
