repeat the procedure. If the engine fails to
start after 4 or 5 tries, open the throttle a
small amount (between 1/8 and 1/4) and
try again. Also if the engine is warm and
fails to start, open the throttle a same
amount and try to start the engine again.
If the engine still fails to start, see page
48.
Slowly return the throttle grip to
the fully closed position so that the engine
does not stall.
HD32003
N
Emergency starting engine (electric
start model)
1. Remove the top cowling.
2. Remove the dust cover.
ZMU05533
6. Insert the knotted end of the
emergency starter rope into the notch
in the flywheel rotor and wind the rope
1 or 2 turn(s) around the flywheel
clockwise.
7. Pull the rope slowly until resistance is
felt. Give a strong pull straight out to
crank and start the engine. If the
engine does not start on the first try,
repeat the procedure.
TIP:
If the engine does not start on
the first try,
3. Remove the electrical system cover by
removing its screw(s).
4. Remove the screw(s) from the plate,
and pull it down.
To Next Page
Loading...
