Network Video Recorder User Manual
130
A PIR (Passive Infrared) alarm is triggered when an intruder moves within the detector vision field.
The heat energy dissipated by a person, or any other warm blooded creature such as dogs, cats,
etc., can be detected.
Step 1 Go to System > Event > Smart Event.
Step 2 Click PIR Alarm.
Step 3 Select a Camera to configure.
Step 4 Check PIR Alarm.
Step 5 Optionally, check Save VCA Picture to save the captured pictures of PIR alarm.
Step 6 Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule.
Step 7 Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions.
Step 8 .Click Apply.
12.14 Enable Smart Search
Purpose
By enabling smart search for IP cameras do not support line crossing and intrusion detection, the
device will analyze line crossing and intrusion events. Supported smart events will be changed after
enabling smart search.
Step 1 Go to System > Event > Smart Event.
Step 2 Check Enable Smart Analysis.
Step 3 Click Yes on popup message box.
To Next Page
Loading...
Need help?
General
