HIKVISION DS-7700NXI-I/S Series User Manual

Network Video Recorder User Manual
147
Connection to a network time protocol (NTP) server can be configured on your device to ensure
the accuracy of system date and time.
Step 1 Go to System > Network > TCP/IP > NTP.
Figure 16-8 NTP Settings
Step 2 Check Enable.
Step 3 Configure NTP settings as need.
 Interval (min): Time interval between two time synchronization with NTP server.
 NTP Server: IP address of the NTP server.
 NTP Port: Port of the NTP server.
Step 4 Click Apply.
16.6 Configure SNMP
Purpose
You can configure SNMP settings to get device status and parameter information.
Before You Start
Download the SNMP software to receive device information via SNMP port. By setting the trap
address and port, the device is allowed to send alarm event and exception message to the
surveillance center.
Step 1 Go to System > Network > Advanced > SNMP.

HIKVISION DS-7700NXI-I/S Series Specifications

General

Brand	HIKVISION
Model	DS-7700NXI-I/S Series
Category	Network Hardware
Language	English