Storage System User Manual
18
HDD failed the HDD detection.
Exception occurs during HDD detection. But it can still work.
HDD is kicked out by an array.
HDD read and writing speed is higher than 10 MB/S during pressure test.
3.1.2 Rescan HDD
Purpose:
If an HDD is installed or uninstalled, you can click Rescan to find or remove the HDD.
Rescanning HDDs may result in HDD status appearing as Unknown. Fresh the interface or click Rescan again to solve
the problem.
3.1.3 Position HDD
Purpose:
HDD bottom indicator flickers after enabling the function. It enables you to find a certain HDD more easily.
Before you start:
Set the flickering time first. For details, refer to 3.5.2 Configure Flickering Time.
Steps:
1. Select HDD(s) to find.
2. Click Position.
3. View the HDD indicator at front panel. The HDD indicator would keep flickering in red color.
3.1.4 Initialize HDD
Purpose:
To recover an HDD when its status is uninitialized or when it is kicked out by an array, you can initialize it.
Steps:
1. Select HDD(s) to initialize.
2. Click Initialize.
3. Confirm the operation.
3.1.5 Detect HDD
Purpose:
To recognize an HDD which is added to a storage system for the first time, detect it.
Steps:
1. Select HDD(s) to detect.
2. Click Detect.
To Next Page
Loading...
Need help?
General
