Access Control Terminal·User Manual
24
Figure 6-13 Communication Settings Interface
Network Settings: It refers to network parameters of the device, including IP address, subnet mask, and gateway address.
Serial Port Settings: When the access control terminal works as a RS-485 card reader, serial port parameters include working
mode, Baud Rate, and RS-485 address.
Wiegand Settings: When the access control terminal works as a Wiegand card reader, Wiegand parameters involve the Wiegand
direction, and the Wiegand mode.
Wi-Fi: You can enable the Wi-Fi function.
6.2.1 Network Settings
Purpose:
On the network settings interface, you can set network parameters of the device.
Steps:
1. Move the cursor to Network (network settings) by using direction keys.
2. Tap the # key to enter the network settings interface.
Figure 6-14 Network Settings Interface
3. Modify network parameters of the device, including IP address, subnet mask, and gateway address.
Note: Tap the key to enter/exit the editing mode.
4. Move the cursor to the OK button, and tap the # key.
6.2.2 Serial Port Settings
Purpose:
When the access control terminal works as the RS-485 card reader, you should set serial port parameters.
Steps:
1. Move the cursor to Serial (serial port settings) by using direction keys on the communication settings interface.
2. Tap the # key to enter the serial port settings interface.
To Next Page
Loading...
