Access Control Terminal·User Manual
26
4. Move the cursor to the OK button, and tap the # key.
Note: Reboot the device after changing the Direction.
6.2.4 Wi-Fi Settings
Steps:
1. Move the cursor to Wi-Fi (Wi-Fi settings) by using direction keys on the communication settings interface.
2. Tap the # key to enter the Wi-Fi settings interface.
Figure 6-17 Wi-Fi Enabling
3. Move the cursor to and tap the # key to enable the WLAN.
Figure 6-18 Wi-Fi Selection
4. Move the cursor to a network, and tap # key to enter the network connection interface.
Figure 6-19 Wi-Fi Settings
5. Enter the password of the network. The password supports numbers, letters (uppercase and lowercase) and symbols.
6. Edit the IP mode, IP address, subnet mask, and gateway address.
7. Move the cursor to the OK button, and tap the # key.
Note: Tap the key to enter and exit the editing mode.
6.3 System Settings
Purpose:
On the system settings interface, you can set system parameters, manage the data, restore default settings, set access control
parameters, and set cameras.
To Next Page
Loading...
Need help?
General
