Access Control Terminal·User Manual
85
5. Click the Ok button to finish adding the card.
Notes:
The card, having added the password, will display in the card list.
You can select the card in the card list, and click the Delete button to delete the password authentication of the selected
card.
7.4 Checking Status and Event
Purpose:
In this section, you are able to anti-control the status of the door and to check the event report of the control point.
7.4.1 Status Monitor
Purpose:
You can anti-control the door status and check the real-time access event information for the control point.
Click the icon on the control panel to enter the interface.
Access Anti-control
Door Anti-control
Purpose:
You can control the status for a single control point (a door) in this section.
Steps:
1. Enter the status monitor page.
2. Click on the icon on the Status Information panel to select a door.
3. Click on the button listed on the upper-left side of the Status Information panel to select a door status for the door.
: Click on the button to open the door once.
: Click on the button to close the door once.
: Click on the button to keep the door open.
: Click on the button to keep the door closed.
: Click on the button to capture the picture.
To Next Page
Loading...
Need help?
General
