HIKVISION DS-K1T105 Series User Manual

Access Control Terminal·User Manual
32
 Enter the card number by swiping the card.
Place the card close to the screen.
 Enter the card number manually.
1) Tap the key to enter the text editing mode.
2) Enter the card number in the textbox.
3) Tap the key to exit the text editing mode.
4. Set the start/end time.
Tap the key to enter and exit the editing mode.
5. Move the cursor to the OK button, and tap the # key.
Note: On the log query display interface, you can view the card number, swiping time, and card reader ID.
6.8 System Information
Steps:
1. Move the cursor to Info (system information) by using direction keys.
2. Tap the # key to enter the system information interface.
Figure 6-30 System Information Interface
3. Move the cursor to Record Capacity or Information by using Left/Right direction keys.
 Record Capacity
Card Capacity: It refers to the maximum amount of cards.
The default maximum card amount is 100,000.
Fingerprint Capacity: It refers to the maximum amount of fingerprints.
Note:
 Fingerprint capacity only supports devices with fingerprint registration function.
 The default maximum fingerprint amounts of devices with fingerprint registering function are as follows.
 Optical device: 9500
 DS-K1T105 series model does not support this function.
 Device Information
In the device information interface, you can view the device name, the serial No., Mac address, and so on.
Figure 6-31 Device Information Interface

HIKVISION DS-K1T105 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T105 Series
Category	IP Access Controllers
Language	English