Access Control Terminal·User Manual
17
Figure 5-2 Modify Network Parameters Interface
6. Input the password and click the Save button to activate your IP address modification.
5.2 Activating via Client Software
The client software is versatile video management software for multiple kinds of devices.
Get the client software from the supplied disk or the official website, and install the software according to the prompts. Follow the
steps to activate the control panel.
Steps:
1. Run the client software and the control panel of the software pops up, as shown in the figure below.
2. Click the icon on the upper-left side of the page, select Access Control to enter the control panel.
Figure 5-3 Control Panel Interface
3. Click the Controller Management icon to enter the Controller Management interface, as shown in the figure below.
To Next Page
Loading...
