HIKVISION DS-K1T105 Series - Communication Settings

Access Control Terminal·User Manual
23
Move the cursor to Add to enter the fingerprint registration interface. See details in step 4 of adding user.
Note: DS-K1T105 series model does not support this function.
 Changing the Password
1) Move the cursor to Change PWD to enter the password changing interface.
2) Enter a new password.
3) Confirm the new password.
Figure 6-12 Password Changing Interface
 Changing the valid date
You can set the start/end time of the user’s permission.
Click the key to enter/exit the editing mode.
 Enabling first card
Tap the # key to enable first card.
Note: After enabling first card, the door remains open during the pre-defined valid duration.
6. Move the cursor to the OK button, and click the # key to confirm the settings.
Deleting the User
Steps:
1. Move the cursor to the user by using direction keys.
2. Tap the # key to pop up an interface for selecting corresponding operations. (Figure 6-9)
3. Move the cursor to Delete User, and tap the # key to enter the deleting interface.
4. Move the cursor to Delete User, Delete PWD only or Delete FP only,.
Delete User: Delete the user and the overall information.
Delete PWD only: Only delete the password set by the user.
Delete FP only: Only delete the fingerprint information of the user.
Note: DS-K1T105 series model does not support this function.
5. Tap the # key to finish the deleting operation.
Note: You can tap * key to return to the main menu.
6.2 Communication Settings
Purpose:
On the communication settings interface, you can set network parameters, the serial port, Wiegand parameters, and Wi-Fi.
Steps:
1. Move the cursor to Comm (communication settings) by using direction keys.
2. Tap the # key to enter the communication settings interface.