Access Control Terminal·User Manual
29
6.3.4 Door Settings
Purpose:
On the door settings interface, you can set door parameters, including Controller Authentication, Card Reader Authentication, Door
Action Time, Delayed Door Alarm, and Anti-passing Back.
Steps:
1. Move the cursor to ACS(door settings) by using direction keys in the system settings interface.
2. Tap the # key to enter the door settings interface.
Figure 6-24 Door Settings Interface
3. Edit door parameters.
Controller Authentication: Set the controller authentication mode for opening the door, that is, Card Only, Fingerprint Only,
Card/Fingerprint, Card & Fingerprint, Card & Password, Fingerprint & Password, Card & Fingerprint & Password.
Card Reader Authentication: Set the card reader authentication mode for opening the door, that is, Card Only, Fingerprint Only,
Card/Fingerprint, Card & Fingerprint, Card & Password, Password & Fingerprint, Card & Password & Fingerprint.
Door Action Time: Set the door action time: 1 ~ 255 s.
Delayed Door Alarm: Set the delayed door alarm threshold: 1 ~ 255 s.
Anti-Passing Back: Set whether to enable the function of anti-passing back.
Notes:
Tap the key to enter and exit the editing mode.
Tap the Right/Left direction keys to choose contents.
Tap the # key to switch the mode between “Yes” mode and “No” mode.
4. Move the cursor to the OK button, and tap the # key.
6.3.5 Setting the Camera
Purpose:
On the camera settings interface, you can set camera parameters.
Note: This function is only supported by terminal with the model of –C.
Steps:
1. Move the cursor to Camera (camera settings) by using direction keys in the system settings Interface.
2. Tap the # key to enter the camera settings interface.
Figure 6-25 Camera Settings Interface
3. Edit camera parameters.
Enable Face Detection: When enabling face detection, the system can detect the face.
Enable Card No. Overlay: When enabling card No. overlay, captured pictures can be overlaid on the card information.
To Next Page
Loading...
