HIKVISION DS-K1T320 Series User Manual

Figure 15-2 Display the Selected Person(s) and Access Point(s)
8.
Aer adding the access groups, you need to apply them to the access control device to take
eect.
1) Select the access group(s) to apply to the access control device.
2)
Click Apply All to Devices start applying all the selected access group(s) to the access control
device or door staon.
3) Click Apply All t
o Devices or Apply Changes to Devices.
Apply All to Devices
This operaon will clear all the existed access groups of the selected devices and then
apply the new access group to the device.
Apply Changes to Devices
This operaon will not clear the existed access groups of the selected devices and only
apply the chang
ed part of the selected access group(s) to the device(s).
4) View the applying status in the Status column or click Applying Status to view all the applied
access group(s).
Note
You can check Displa
y Failure Only to lter the applying results.
The selected persons in the applied access groups will have the authorizaon to enter/exit the
select
ed doors/door staons with their linked card(s) or ngerprints.
9.
Oponal: Click
to edit the access group if necessary.
DS-K1T320 Series Face Recoginon Terminal User Manual
119

HIKVISION DS-K1T320 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T320 Series
Category	Touch terminals
Language	English