HIKVISION DS-K1T320 Series - Card Settings

Exit Buon Type
You can set the exit buon as Remain Open or Remain Closed according to your actual needs.
By default, it is Remain Open.
Door Lock Powering O Status
Y
ou can set the door lock status when the door lock is powering o.
By default, it is Remain
Closed.
Extended Open Duraon
The door contact can be enabled with appropriate delay aer person with extended access
needs swipes her/his card.
Door Remain Open Duraon with First Person
Set the door open duraon when rst person is in. Aer the rst person is authorized, it allows
mulple persons access the door or other authencaon acons.
Duress Code
The door can open by inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Super Password
The specic person can open the door by inpung the super password.
Note
The duress code and the super code should be dierent.
Set Terminal Parameters
You can set terminal parameters for accessing.
Click Conguraon → Access Con
trol → Terminal Parameters .
You can set Working Mode as Access Control Mode. The access control mode is the device normal
mode. You should authencate your credenal for accessing.
Click Save to save the sengs aer the conguraon.
14.6.11 Card Sengs
Set Card Security
Click Conguraon → Car
d Sengs → Card Type to enter the sengs page.
Set the parameters and click Save.
Enable NFC Card
DS-K1T320 Series Face Recoginon Terminal User Manual
92