HIKVISION DS-K1T320 Series - Face Parameters Settings

Sector
Enable the funcon and set the encrypon sector. By default, Sector 13 is encrypted. It is
recommended to encrypt sector 13.
Enable CPU Card
The device can read the data from CPU card when enabling the CPU card funcon.
Set Card Authencaon Parameters
Set the card reading content when authencate via card on the device.
Tap Conguraon → General Sengs → Card Authencaon Sengs .
Figure 8-10 Card Authencaon Page
Select a card authencaon mode and tap Sa
ve.
Full Card No.
All card No. will be read.
Wiegand 26 (3 bytes)
The device will read card via Wiegand 26 protocol (read 3 bytes).
Wiegand 34 (4 bytes)
The device will read card via Wiegand 34 protocol (read 4 bytes).
8.4.10 Face Parameters Sengs
Set face parameters.
Face Parameters Sengs
Tap Conguraon → Smart → In
telligent Parameter .
DS-K1T320 Series Face Recoginon Terminal User Manual
67