HIKVISION iDS-TCV507-BIR/1550

4.
Click Save.
1.5.4 Set Scene Mode
Set the capture type, capture mode, and speed detecon mode for the applicaon mode.
Steps
Note
●
Not all the applicaon modes support scene mode sengs.
●
The scene mode parameters vary with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Applicaon Mode .
2.
Select Trigger Mode.
3.
Set Capture Type.
Motor Vehicle, Non-Motor Vehicle, and Pedestrian
The motor vehicles, non-motor vehicles, and pedestrians in the scene will be recognized and
captured.
Motor Vehicle
Only the motor vehicles in the scene will be recognized and captured.
Non-Motor Vehicle
Only the non-motor vehicles in the scene will be recognized and captured.
4.
Set Capture Mode.
Flash
It adopts the separate exposure, and is applicable to the
condion of viewing face pictures
clearly at night.
Note
In ash mode, if you enable driving on the lane and lane change detecon, the ash light will
not on, but captures will be triggered normally.
Strobe
It adopts the frame extracng, and the captured pictures share the same exposure
parameters with the video image. It is applicable to the condion of capturing license plates
only.
5.
Set Speed
Detecon Mode.
Radar
Speed
detecon via radar.
Video
Speed detecon via video. Click Calibraon to calibrate speed via video. Refer to Calibrate
Speed via Video for details.
Network Trac Camera Conguraon Manual
26