Post-record Time
The me aer the violaon recording ends.
5.
Click Save.
1.5.8 Set Supplement Light Linkage
You can link supplement light(s) to the specic lane(s).
Before You Start
Connect the supplement light(s) to the corresponding interface(s) of the device.
Steps
Note
●
Not all the applicaon modes support supplement light linkage.
●
The supplement light linkage parameters vary with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Applicaon Mode .
2.
Select Trigger Mode.
3.
Check the corresponding supplement light triggering output interface(s).
4.
Select Flashlight Mode.
Simultaneous
The supplement lights of all the lanes will be triggered simultaneously when there is vehicle
passing.
Sequenal
Only the supplement light of the specic lane will be triggered when there is vehicle passing.
Note
If LED supplement light is adopted, the recognion rate of the vehicle body color cannot be
guaranteed at night.
5.
Click Save.
1.5.9 Set Lane Speed Limit Parameters
Set the speed limit parameters for dierent types of vehicles.
Steps
Note
●
Not all the applicaon modes support lane speed limit parameters.
●
The lane speed limit parameters vary with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Applicaon Mode .
Network Trac Camera Conguraon Manual
30