HIKVISION NETWORK CAMERA - Page 87

User Manual of Network Camera
87
(3)Select the area by clicking the area No..
(4)Slide the cursor to adjust the sensitivity and proportion of object on the area
for the selected area.
(5)Set the arming schedule and linkage method as in the normal configuration
mode.
(6)Click Save to save the settings.
 Day/Night Auto-Switch
Steps:
(1)Draw the detection area as in the normal configuration mode. Up to 8 areas are
supported.
(2)Select Auto-Switch for Switch Day and Night Settings.
Figure 6-49 Day/Night Auto-Switch
(3)Select the area by clicking the area No.
(4)Slide the cursor to adjust the sensitivity and proportion of object on the area
for the selected area in the daytime.
(5)Slide the cursor to adjust the sensitivity and proportion of object on the area
for the selected area at night.
(6)Set the arming schedule and linkage method as in the normal configuration