To Next Page

To Previous Page

Sub Card Reader Posion

You can select sub card reader posion as dierent or same side as the main card reader.

Authencaon

Select an authencaon mode according to your actual needs from the drop-down list.

Recognion Interval

You can set the interval between 2 connuous recognion of a same person during the

authencaon. In the congured interval, Person A can only recognized once. If another person

(Person B) has recognized during the interval, Person A can recognized again.

Alarm of Max. Failed Aempts

Enable to report alarm when the card reading aempts reach the set value.

Communicaon with Controller Every

When the access control device cannot connect with the card reader for longer than the set

me, the card reader will turn oine automacally.

Max. Interval When Entering Password

When you entering the password on the card reader, if the interval between pressing two digits

is longer than the set value, the digits you pressed before will be cleared

automacally.

OK LED Polarity/Error LED Polarity

Set OK LED Polarity/Error LED Polarity of the access control device according to the card reader

parameters. Generally, adopts the default sengs.

Tampering Detecon

Enable the an-tamper detecon for the card reader.

Set Door Parameters

Click Conguraon → Access Control → Door Parameters .

Face Recognion Terminal User Manual

HIKVISION Ultra Series User Manual

Other manuals for HIKVISION Ultra Series