HiLook DVR-E00G-B Series - Camera Management; Configure Signal Input

Check it to enable the server authencaon feature.
User Name
The user account of email sender for SMTP server authencaon.
Password
The password of email sender for SMTP server authencaon.
SSL/TLS
(Oponal) Enable SSL/TLS if it is required by the SMTP server.
Aached Picture
(Oponal) If events are triggered, it will send images as email aachment.
Sender
The sender name.
Sender's Address
The sender's email address.
Select Receiver
Select a receiver. Up to 3 receivers are available.
Receiver
The receiver name.
Receiver's Address
The receiver's email address.
Note
For network cameras, the event images are directly sent as the email aachment. One network
camera only sends one picture.
3. Oponal: Click Test to send a test email.
4. Click Apply.
5.3 Camera Management
5.3.1 Congure Signal Input
For certain digital video recorder models, you can congure the analog and IP signal input types.
Steps
1. Go to Conguraon → Camera → Analog → Analog .
2. Select signal input type as HD/CVBS or IP for each channel.
HD/CVBS
Digital Video Recorder User Manual
21