HiLook DVR-E00G-B Series - Configure Alarm Linkage Action

5.3.6 Congure Alarm Linkage Acon
Alarm linkage acons will be acvated when an alarm or excepon occurs.
Steps
1. Click Linkage Acon.
2. Set normal linkage
acons, alarm output linkage acons, trigger channel, etc.
Alarm Pop-up Window
The local monitor will pop up the alarming channel image when an alarm is triggered. It
requires to select the alarming channel(s) in Trigger Channel.
Buzzer Alarm
It will trigger a buzzer beep when an alarm is triggered.
Nofy Surveillance Center
The device will send an excepon or alarm signal to the remote client soware when an
alarm is triggered.
Send Email
It will send an email with alarm informaon when an alarm is triggered.
PTZ Linkage
It will trigger PTZ acons (e.g., call preset/patrol/paern) when smart events occur.
Audio and Light Alarm Linkage
For certain network cameras, you can set the alarm linkage acon as audio alarm or light
alarm.
Note
●
Ensure your camera supports audio and light alarm linkage.
●
Ensure the audio output and volume are properly congured.
●
If you require to set audio and light parameters, please log into the network camera via
web browser to
congure them.
3. Click Apply.
Digital Video Recorder User Manual
26