HiLook DVR-E00G-B Series - OSD Settings

Add Network Camera Manually
Before You Start
●
Ensure your network camera is on the same network segment with that of your video recorder.
●
Ensure the network connecon is valid and correct.
●
Ensure the network camera is
acvated.
Steps
1. Go to
Conguraon → Camera → IP Camera .
2. Click in Added Device List.
3. Set network camera parameters, including IP address, protocol, management port, etc.
4.
Oponal: Enable Use Camera Acvaon Password to use the device password to add network
camera(s).
5. Oponal: Click Add More to add another network camera.
6. Click Add.
Figure 5-9 Add Network Camera
Edit Connected Network Camera
You can edit the IP address, protocol and other parameters of the added network cameras.
Digital Video Recorder User Manual
23