144
────────────────────────────────────────────────────
5.6 Testing Using EXT I/O
────────────────────────────────────────────────────
Conditions set for next
measurement (TRIG signal input
Min 1 ms
Min 100 μs
LD1
------------
LD2
────
LD3
────
LD4
────
LD5
────
PNL0
─────
-
PNL1
─────
-
PNL2
─────
-
TRIG
─────
-
5. When each trigger signal arrives and the panel number is changed, the
process follows the timing shown in the next figure. (The figure shows that
the panel numbers 6,8 and 10 are tested first and then the panel numbers 2
and 3 are tested.)
6. When quitting continuous testing, press the
key to return to the initial
screen.
To Next Page
Loading...
