Hioki 3522-50 - Connection Method

151
────────────────────────────────────────────────────
5.9 9442 PRINTER (option)
────────────────────────────────────────────────────
5.9.2 Connection Method
WARNING
To avoid electrocution, turn off the power to all devices before
plugging or unplugging any cables or peripherals.
Unit 9442 PRINTER
Frame Frame
D-sub25pin Male D-sub9pin Male
8
○
2
○
3
○
4 ○
5
○
6
○
7 ○
20
○
22
○
○ 1
○ 2
○
3
○ 4
○
5
○
6
○ 7
○
8
○
9
6. After setting for the switch number 8 of DIP SW 3 is made, press the ON
LINE or FEED switch to complete settings.
"Dip SW setting complete!!" is printed out.
(3) Setting of the 9593-01 RS-232C INTERFACE
Set the communication setting switch on the left of the RS-232C connector
to ON.
Set the 9442 PRINTER and the 9593-01 RS-232C INTERFACE referring to
Section 5.9.1.
1. Turn off the power of the main unit and printer.
2. Install the 9593-01 RS-232C INTERFACE to the main unit.
(For details on installing, see the 9593-01 Instruction Manual.)
3. Connect the 9446 CONNECTION CABLE between the main unit and the
printer.