Installation GREYHOUND Switch
Release
01
04/2016
39
2Installation
The devices have been developed for practical application in a harsh
industrial environment.
On delivery, the device is ready for operation.
Perform the following steps to install and configure the device:
Checking the package contents
Installing the SD card (optional)
Mounting the cover panel and the power supply unit (optional)
Mounting a media module (optional)
Installing and grounding the device
Connecting the terminal blocks
Operating the device
Installing an SFP transceiver (optional)
Connecting data cables
Filling out the inscription label
2.1 Checking the package contents
Check whether the package includes all items named in the section
“Scope of delivery” on page 70.
Check the individual parts for transport damage.
2.2 Installing the SD card (optional)
Prerequisite:
Only use the AutoConfiguration Adapter ACA31 storage medium.
See “Accessories” on page 71.
Proceed as follows:
Deactivate the write protection on the SD card by pushing the write-
protect lock towards the middle of the card.
Push the SD card into the slot with the beveled corner on the right side.
To Next Page
Loading...
Need help?
General
