Quick Start up 10
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
Quick Start up IP Address
To view the network parameters the operator can access the device by the following three methods.
Simple Network Management Protocol - SNMP
Telnet
Web Browser
Note: Helpful Hint: The user should do a ‘copy system:running-config nvram:startup-con-
fig’ after configuring the network parameters so that the configurations are not lost
users passwd <username>
(Global Config Mode)
Allows the user to set passwords or change passwords
needed to login
A prompt appears after the command is entered requesting
the users old password. In the absence of an old password
leave the area blank. The operator must press enter to exe-
cute the command.
The system then prompts the user for a new password then a
prompt to confirm the new password. If the new password
and the confirmed password match a message will be dis-
played.
User password should not be more than eight characters in
length.
copy system:running-config
nvram:startup-config
(Privileged EXEC Mode)
This will save passwords and all other changes to the
device.
If you do not save the configuration by doing this com-
mand, all configurations are lost when a power cycle is per-
formed on the networking device or when the networking
device is reset.
logout
(User EXEC and Privileged
EXEC Modes)
Logs the user out of the networking device
Table 4. Quick Start up IP Address
Command Details
show network
(User EXEC Mode)
Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 0.0.0.0
Subnet Mask - IP Subnet Mask for the interface
Default is 0.0.0.0
Table 3. Quick Start up User Account Management
Command Details
To Next Page
Loading...
Need help?
General
