Hirschmann PowerMICE Reference Manual

Quick Start up 11
© 2001- 2006 Hirschmann Automation and Control GmbH. All Rights Reserved.
Quick Start up Factory Defaults
Default Gateway - The default Gateway for this interface
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC Address used for
in-band connectivity
Network Configurations Protocol (BOOTP/DHCP) - Indicates
which network protocol is being used.
Default is DHCP
Network Configurations Protocol HiDiscovery - Indicates the state
of HiDiscovery.
Default is Read-Write
Management VLAN Id - Specifies VLAN id
Web Mode - Indicates whether HTTP/Web is enabled.
JavaScript Mode - Indicates whether java mode is enabled.
network parms <ipaddr>
<netmask> [gateway]
(Privileged EXEC Mode)
Sets the IP Address, subnet mask and gateway of the router. The IP
Address and the gateway must be on the same subnet.
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
Gateway Address range from 0.0.0.0 to 255.255.255.255
Table 5. Quick Start up Factory Defaults
Command Details
clear config
(Privileged EXEC Mode)
Enter yes when the prompt pops up to clear all the configura-
tions made to the networking device.
copy system:running-con-
fig nvram:startup-config
Enter yes when the prompt pops up that asks if you want to
save the configurations made to the networking device.
reload (or cold boot the network-
ing device)
(Privileged EXEC Mode)
Enter yes when the prompt pops up that asks if you want to
reset the system.
The user can reset the networking device or cold boot the net-
working device, both work effectively.
Table 4. Quick Start up IP Address
Command Details

Hirschmann PowerMICE Specifications

General

Brand	Hirschmann
Model	PowerMICE
Category	Network Router
Language	English