Installation RSP 20/25/30/35
Release
08
08/2014
25
2Installation
The devices have been developed for practical application in a harsh indus-
trial environment.
On delivery, the device is ready for operation.
The following steps should be performed to install and configure a device:
Checking the package contents
Installing the SD card (optional)
Installing and grounding the device
Installing an SFP transceiver (optional)
Connecting the terminal blocks
Operating the device
Connecting data cables
Filling out the inscription label
2.1 Checking the package contents
Proceed as follows:
Check whether the package includes all items named in the section
“Scope of delivery” on page 47.
Check the individual parts for transport damage.
2.2 Installing the SD card (optional)
Note: Only use the AutoConfiguration Adapter ACA31 storage medium.
See “Accessories” on page 48.
Proceed as follows:
Deactivate the write protection on the SD card by pushing the write-
protect lock towards the middle of the card.
Push the SD card into the slot with the beveled corner facing upwards.
Tighten the thumb screw hand-tight to fix the SD card.
To Next Page
Loading...
Need help?
General
