Installation RSP 20/25/30/35
Release
08
08/2014
33
2.7 Connecting data cables
In general, adhere to the following recommendations for data cable connec-
tions in environments with high electrical interference levels:
Keep the length of the data cables as short as possible.
Use optical data cables for the data transmission between the buildings.
When using copper cables, provide a sufficient gap between the power
supply cables and the data cables. Ideally, install the cables in separate
cable channels.
Use shielded cables.
Connect the data cable according to your requirements.
For further information see “Device name and product code” on page 13.
2.8 Filling out the inscription label
The inscription label for the IP address on the front of the device helps you
identify your device.
To Next Page
Loading...
Need help?
General
