Hirschmann RSP 20 User Manual

32
Installation RSP 20/25/30/35
Release 08 08/2014
With non-redundant supply of the operating voltage, the device reports the
loss of an operating voltage. You can prevent this message by applying the
operating voltage via both inputs, or by changing the configuration in the
Management.
2.5.4 Signal contact
 Connect the signal contact wires with the connectors of the terminal block.
 Fasten the wires connected by tightening the terminal screws.
2.6 Operating the device
Relevant for North America:
The torque for tightening the working voltage terminal block on the device is
4.5 lb-in (0.51 Nm).
The torque for tightening the terminal block for the signal contact on the
device is 3 lb-in (0.34 Nm).
Proceed as follows:
 Use screws to secure the connectors to the device.
 Enable the working voltage.

Hirschmann RSP 20 Specifications

General

Brand	Hirschmann
Model	RSP 20
Category	Switch
Language	English