Error code
(SSB2)
Description
C3B9 The specified S-VOL LUN is not defined; or the LUN includes a CU LDEV that is not
supported by the primary system.
C3BC TC is not installed on the secondary system.
C3BE These volumes cannot be specified as a TC S-VOL:
SI S-VOL not in PSUS status
SI reserved volume
SI P-VOL in the process of reverse copy
C3BF A TC S-VOL cannot be specified as a SI S-VOL, reserved volume, or P-VOL in the
process of reverse copy.
C3C7 A request for a Paircreate operation was rejected because the specified volume was
already part of a TC or UR pair (including journal volumes).
C3CA The S-VOL is reserved; or a secondary system, S-VOL, or the path between primary
system and secondary system is in the BUSY status.
C3CD The S-VOL is a SI volume.
C3D2 The DKC type of the secondary system is not supported by TC.
C3D4 A pair cannot be created because the P-VOL is being used by Volume Migration.
C3D6 The specified S-VOL is unavailable because the connecting port cannot recognize it.
C3D7 The pair status of the S-VOL is invalid.
C3D8 The pair cannot be created because the volume specified for the S-VOL is a system
volume.
C3D9 The pair cannot be created if the TC S-VOL corresponds to any of the following:
The volume is a DP-VOL; the pair using the volume is an SI, Thin Image, or Copy-on-
Write Snapshot pair, or a Volume Migration reserve volume.
The volume is a DP-VOL and an addition to volume capacity is in progress, or pages are
being released.
The capacity of the volume is different from the capacity of the P-VOL
The volume is initialized by SI
C3DB S-VOL pair status is not PSUS or PSUE.
C4DE The pair cannot be created because the remote path is not valid.
C4FC The required amount of shared memory for the operation is not installed in the
secondary system.
CB12 TC and UR cannot be mixed in the consistency group.
CB19 The secondary system consistency group cannot be deleted because the Takeover
command reversing operations between the P-VOL and S-VOL failed.
CB1A The secondary system consistency group was abnormally terminated because the
Takeover command reversing operations between the P-VOL and S-VOL failed.
CB1D No dummy volume can be created in the S-VOL.
CB1F The secondary system does not support TC.
Troubleshooting
10-13
Hitachi TrueCopy® User Guide for Hitachi Virtual Storage Platform Gx00 and Fx00 Models
To Next Page
Loading...
