Error code
(SSB2)
Description
CB20 In referring to the function bit, the system information reference was abnormally
terminated.
CB21 In a pairresync operation, all difference setting was abnormally terminated.
CB23 An internal error occurred.
CB60 TC is not installed in the secondary system.
CB66 A TC pair cannot be created or resynchronized because the bitmap areas are not
available for either of the following reasons:
• Free space in shared memory is insufficient in the secondary system.
• The pool capacity is insufficient in the DP pool of the volume specified as S-VOL.
CB67 An additional shared memory is not installed in the secondary system.
CB68 A TC pair cannot be created or resynchronized because free space of the shared
memory in the primary system is insufficient and the differential bitmap areas are not
available.
CB69 The number of pairs exceeds the maximum number that can be created in a single
consistency group.
CB6E The Paircreate operation cannot run because the P-VOL is an external storage system
volume.
CB6F The Paircreate operation cannot run because the S-VOL is an external storage system
volume.
CB71 The pair cannot be created because the P-VOL is a migration volume of another
vendor's storage system.
CB73 The pair cannot be created because the S-VOL is a migration volume of another
vendor's storage system.
CB75 The device is not recognized correctly.
CB76 The Paircreate operation cannot run because the paths are specified per storage
system.
CB77 The used capacity of the Data Retention Utility software product on the secondary
system exceeds the license capacity.
CB78 The Paircreate operation cannot run because the specified S-VOL is defined as the
command device.
CB7E A request for a Paircreate operation was rejected because the specified S-VOL belongs
to a different CLPR than the registered consistency group's CLPR.
CB9E A request for a paircreate operation was rejected in the RCU because the configuring
function for one or more of the specified consistency groups on the MCU and/or RCU is
unsupported.
CBD7 The storage system is in internal processing. Try the operation again.
CBD8 A pair cannot be created because the specified primary system is one of the following:
• A journal volume used for UR.
• A UR secondary volume that is in a status other than Suspend.
CBDA The Paircreate operation cannot run because the used capacity of the Data Retention
Utility on the secondary system exceeds the license capacity.
10-14
Troubleshooting
Hitachi TrueCopy® User Guide for Hitachi Virtual Storage Platform Gx00 and Fx00 Models
To Next Page
Loading...
