1. RJ45
Connect a LAN cable from Ethernet.
2. MONITOR OUT
Standard 15-pin VGA connection socket
to connect to a display monitor. Loop thru
only for COMPUTER IN.
3. USB POWER
Connect a USB cable for USB host.
(Support 5V/1.5A output as long as the
projector Power On.)
4. COMPUTER IN
Standard 15-pin VGA connection socket
to connect to RGB, high-denition
component input or PC. The projector will
automatically detect the resolution of the
input signal.
5. 3D SYNC (5V)
IN: Connect 3D-sync in cable from a
computer or an enabled device.
OUT: Connect 3D IR glasses receiver unit.
6. HDBaseT
HDBaseT is a technology to transmit
image, sound, Ethernet or serial control
signal via LAN cable.
7. DVI-D
Connect to DVI source.
8. VIDEO
Connect the composite cable from a video
device.
9. SERVICE
For service personnel only.
10. HDMI 1
HDCP compatible digital picture input;
connects to sources using HDMI or DVI.
11. HDMI 2 / MHL
Connect to a MHL-compatible device by
using an HDMI/MHL cable.
12. RS-232C
IN: 9-pin D-sub socket. Connects your
PC or automatic home theater /control
system.
OUT: Connects to another projector (same
model) for RS-232 control.
13. BNC
Connects to ve BNC inputs for PC (R/B/
G/H/V) or for component (YPbPr) picture
source and channel (Hs, Vs) source.
14. AUDIO IN (L/R)
Stand RCA connector. Connect an audio
source input. (Available for Component
(Computer) or Video source.)
15. AUDIO OUT (L/R)
Stand RCA connector. Connector to an
audio amplier device.
16. AUDIO IN (Mini jack)
3.5 mm, mini phone jack. Connect
an audio source input. (Available for
Computer, BNC, DVI source.)
17. WIRED REMOTE
IN: Usable wired-remote-control with
accessory cable.
OUT: Connect to another projector (same
model) “WIRE REMOTE IN” for
serial control.
18. 12V TRIGGER (3.5mm, mini phone jack)
Offers 12V (+/- 1.5) of output for 350 mA
monitor relay with short circuit protection.
To Next Page
Loading...
