OSD description
63
Note: You need to enable the 3D source (some 3D DVD content may have a 3D on-off selection
feature).
Note: You need DLP link 3D or IR 3D shutter glasses. With IR 3D shutter glasses, you need to
install a driver on your PC and connect a USB emitter.
Note: The 3D mode of the OSD needs to match the type of glasses (DLP link or IR 3D).
Note: Power on the glasses. Glasses normally have a power on -off switch. Each type of glasses
has their own conguration instructions. Please follow the conguration instructions that
come with your glasses to nish the setup process.
Note: Passive 3D is not going to support thru 3D Sync In/Out.
Note: Since different types of glass (DLP link or IR shutter glass) have their own setting
instructions, Please follow the guide to nish the setup process.
Advanced 2
Press ENTER / ► to enter the Advanced 2 menu.
• Test Pattern
The projector comes with some standard built-in patterns for testers to calibrate the equipment.
The options are RGB Ramps, Color Bars, Step Bars, Checkboard, Grid, Horizontal lines, Vertical
lines, Diagonal lines, Horizontal Ramp, Vertical Ramp, White, Red, Green, Blue, Black and Off.
• H Image Shift
Press ◄► to enter and set whole Image horizontal shift without cropped.
• V Image Shift
Press ◄► to enter and set whole Image vertical shift without cropped.
4 Corner
Press ▲▼◄► to correct 4 corner picture bias.
Press ▲▼◄► to correct top
left corner picture bias
Press ▲▼◄► to correct top
left corner picture bias
Press ▲▼◄► to correct
bottom left corner picture bias
Press ▲▼◄► to correct
bottom right corner picture bias
To Next Page
Loading...
