Projector installation
36
HDBaseT connection
HDBaseT is a technology to transmit image signal using a LAN cable.
Connect Cat5e/Cat6 cable from HDBaseT TX Box for HDBaseT signal received.
LAN Connection - When this connector to be the LAN (RJ-45) function. Connect it to computer or
Hub. Key in the correct IP Address or the computer host name which same as the projector’s host
name then you can remote control the projector by internet.
Video Signal - When this connector to be the video signal input. Connect it to HDBaseT output
equipment(Such as high-denition TV source, Blu-ray Player....etc).
RS-232 Connection: When the projector connects to HDBaseT by RS-232 communication, the
projector can be controlled with RS-232 commands from the computer. For details of RS-232
commands, refer to RS-232 Communication command table.
Use LAN cables of up to 100m long. Exceeding this length, the image will be deteriorated, and even
experience malfunction on LAN transmission.
Lan: PC, Hub
Video: HDBaseT output equipment (Such as high-definition TV source,
Blu-ray Player ... etc.)
To Next Page
Loading...
