Remote control
24
Range of effective remote control signal reception
The diagram below illustrates the range of effective remote control signal reception (Unused new
battery).
30°
30°
7m
Note: Avoid placing the remote control at places of high temperature or humidity as it could
cause the remote control to malfunction.
Installing batteries in the remote control
1. Remove the cover by sliding it in the direction indicated by the arrow.
2. Insert two new AAA batteries (observe the polarity).
3. Replace the cover.
1
+
+
-
-
2
+
3
Note: Be sure to insert the batteries in the corresponding orientations to match the polarities.
Note: Do not mix new batteries with used batteries as it would shorten the life of new batteries
or cause leakage.
Note: Only used AAA batteries as instructed; do not attempt to insert different types of batteries
into the remote control.
Note: If the remote is going to be unused for long periods of time, be sure to remove the batteries
to prevent leakage, which could damage the remote control.
Note: The liquid contents in the batteries is harmful to the skin; do not touch the leakage with
your bare hands directly. When installing fresh batteries, be sure to clean up the leakage
thoroughly.
Note: Under most circumstances, you only need to point the remote control towards the screen
and the IR signal would be reected off the screen and picked up by the IR sensor on the
To Next Page
Loading...
