OSD description
57
Auto Image
When Auto image was selected in the OSD menu, press ENTER to execute the automatic picture
adjustment function.
By executing this function, the projector will resync the picture. Use this function when the
picture source is unstable or when you notice deterioration in picture quality and the projector will
automatically adjust the picture size, phase and timing. (The adjustment also applies to PinP input
source).
This function is identical to AUTO on the remote control. You can simply use the hot key on the
remote control to execute this function.
Advanced
Press ENTER / ► to enter the Advanced menu.
• Brilliant Color
Press ◄► to adjust the brilliant color of the projected image.
This feature utilizes a new color-processing algorithm and system level enhancements to enable
higher brightness while providing truer, more vibrant colors in picture.
• Sharpness
The adjustment of sharpness primarily changes the value of high frequency detail. You can connect
the projector to an external picture source to display an picture resembling the one shown below to
adjust the picture sharpness.
The picture Fig 8 illustrates the results of direct sharpness adjustment using a random picture:
• Gamma
Using different color gamut will create different color presentation in the projected picture.
Generally speaking, when the surrounding are darker, it is recommended that Gamma be set higher
to yield better picture quality in darker regions by sacricing details in brighter areas. In contrast,
when projecting brighter pictures, you can set the Gamma lower to give up details in the darker
areas to make the brighter areas more visible.
The options are 1.8, 2.0, 2.2, 2.4, B&W and Linear.
• Color Temperature
You can choose from Warm, Normal and Cold.
Color temperature refers to the change in light color under different energies that is perceived by
the naked eye. The change of color temperature from Warm to Cold for visible light goes from
orange red → white → blue .
As color temperature rises, the picture will appear to be bluer; as it decreases, the picture will
appear redder. When you choose “Native”, the projector will disable the white adjustment function
of the input device.
• Video AGC
Press ◄► to enter and enable or disable the Automatic Gain Control for video source.
To Next Page
Loading...
