Projector installation
43
Powering the projector on or off
Powering on the projector
Press on the projector or on the remote control to start up the projector.
The POWER LED will now ash green. The startup screen will display in approximately 30 seconds.
The rst time you use the projector, you can select your preferred language from quick menu after the
startup screen display.
If security lock is enabled. Refer to “ Page 45 : Setting an access password (security lock) ”.
Connect the power cord to the projector
Connect the female side of the power cord
to power input socket of projector.
Turning off the projector
Press on the projector or on the remote control. The message “Power Off? /Press Power again”
will appear on the screen. Press the button again while the message appears. When the projector has
been turned off, the cooling fan will remain in operation for approximately 10 seconds.
To Next Page
Loading...
