OSD description
65
• Extreme Dimming
When set to Extreme Dimming mode, the brightness will 25% of the normal brightness.
Operate temperature must lower then 35°C. The cooling fan will auto slow down the speed. If the
surrounding environment is sufciently dark or if you do not require intense brightness, you can
set the power mode to Extreme Dimming to save the power.
Note: Extreme Dimming is automatically selected between 35~40°C(95~104°F), when the
temperature is higher then 35°C. The fan speed will fully operational to exhaust the heat.
This situation will not save the power.
• Custom Light
If the picture brightness at Extreme Dimming mode is too dark for you and the Normal mode
gets too bright, you can set it to custom to specify the power mode to make ne adjustments to the
brightness of the projected picture. You could encounter situations where the picture from projector
A being brighter than projector B. When this occurs, you can use this function you could encounter
situations where the picture from projector A being brighter than projector B. When this occurs,
you can use this function to ne tune the brightness of the two projectors to achieve consistent
picture brightness. To access this function, go to the MENU Settings 2 Light Mode
Custom Light and adjust accordingly.
Reset All
Press ENTER / ► to reset all settings to default values.
Note: All of OSD function are reset to default except Language, Security Lock, Source,
3D(include Sync Invert & Format), Test Pattern, Remote ID, Network.
Status
Press ENTER / ► to enter the Status menu.
• Active Source
Display the activated source.
• Video Information
Displays resolution/video information for RGB source and color standard for Video source.
• Laser Hours
Laser hour used information is displayed.
• Software Version
Showing system software version.
• Remote ID
Showing Remote Controller ID.
• Serial Number
Showing serial number of product.
Advanced 1
Press ENTER / ► to enter the Advanced 1 menu.
• Menu Position
You can use this function to designate which area on the picture the OSD menu will appear. As you
can see from the diagram below, there are ve positions where you can choose to have the OSD
menu displayed. The default setting is “Center”.
• Translucent Menu
Press ◄► to enter and select OSD background translucent level.
• Low Power Mode
Press ◄► to enter and turn Low Power Mode On or On By Lan.
Note: About “On By Lan”, RJ45 will support to be waked up in this mode(Under 3W) but scalar
won’t.
To Next Page
Loading...
