OSD description
74
• HDBaseT/IR
Press ENTER / ► to enter the HDBaseT/IR menu.
• HDBaseT– IR/RS232/RJ45
Press ◄► to enter and enable or disable HDBaseT–IR/RS232/RJ45 Control.
• Front IR
Press ◄► to enter and enable or disable Front IR.
• Rear IR
Press ◄► to enter and enable or disable Rear IR.
Note: Enable
HDBaseT– IR/RS232/RJ45 control
function when you desire to use HDBaseT TX
box. (Remove RS232 and RJ45/LAN control function from Projector to HDBaseT TX box.)
See HDBaseT– IR/RS232/RJ45 control function table.
Note: When HDBaseT– IR/RS232/RJ45 enable,
Low Power Mode
will auto set to
On by Lan
.
Note: HDBaseT– IR/RS232/RJ45 control is disabled when the HDBaseT TX box signal is cutoff.
HDBaseT– IR/RS232/RJ45 control function table
Control
Side
Function
Projector Mode
Remark
Low Power Mode
On (<0.5W)
Low Power Mode
On by Lan (<3W)
HDBaseT control
Enable Low Power
Mode On by
HDBaseT (<6W)
Projector
Front-IR (wireless) O O
O (Can disable by
OSD)
Rear-IR (wireless) O O
O (Can disable by
OSD)
RS-232 O O
RJ45/LAN X O
Wired remote O O
HDBaseT
TX Box
HDBT-IR (wireless) X X O
RS-232 X X O
RJ45/LAN X X O
Wired remote X X O
User can connect wired
remote at HDBaseT TX
side to get the wired
function.
O: Enable X: Disable
Advanced 2
Press ENTER / ► to enter the Advanced 2 menu.
• Sleep Timer
Press ◄► to enter and set sleep timer. The projector automatically turns off after the preset period
of time.
• Source Filter
Press ENTER / ► to enter the Source Filter menu.
Press ◄► to enter and enable or disable the desire source.
Custom Light
In Custom Light mode press ◄► to enter and adjust the brightness of the projectors to similarity.
Note: When Light Mode set to Custom Light, Custom Light function Enable.
To Next Page
Loading...
