Hitachi LP-WU6600 - Lens Shift Adjustment Guide

Projector installation
30
Horizontal and vertical lens shift
In addition to using the adjustable feet to adjust projection angle, you can also use the Lens Shift
function to adjust the projected picture.
Lens shift
1. Turn the VERTICAL adjuster fully counter clockwise. Then turn it clockwise and adjust the
vertical lens position upward.
2. Turn the HORIZONTAL adjuster clockwise or counter clockwise to adjust the horizontal lens
position.
VER
TICAL
adjuster
HORIZONT
AL
adjuster
Note for adjusting the lens shift
1. Adjust the lens shift / zoom / focus after 30 minutes have passed since the projector turned on.
2. Slight changes of the image position and/or focus may occur within 30 minutes after the
projector was turned on. If the room temperature and humidity have changed after adjusting the
lens shift / zoom / focus, readjust them as necessary.
3. Set the image size including the margin from the screen edge in anticipation of the changes
after installation.
4. When adjusting the lens shift vertically, nish adjusting lens shift by moving the projected
screen upward. If you nish adjusting the lens shift by moving the projected screen downward,
the projected screen may be misaligned slightly downward over time.