Hitachi VSP F1500

Login
user
Command
device
Operating range Reference
Configuration
change
Command
operations
using the
out-of-
band
method
and the shared ports after
logging in.
User 10 CM0 Can operate only in the
range of resource group 10
and 11, and the shared ports
after logging in.
Operable Operable Operable
CM10 Can operate only in the
range of resource group 10,
and the shared ports after
logging in.*
Operable Operable Inoperable
CM11 Can operate only in the
range of resource group 11,
and the shared ports after
logging in.*
Operable Operable Inoperable
CM20 Cannot log in. Nothing is displayed or the
operation authority error.
Operation authority
error
Inoperable
User 20 CM0 Can operate only in the
range of resource group 20,
and the shared ports after
logging in.
Operable Operable Operable
CM10 Cannot log in. Nothing is displayed or the
operation authority error.
Operation authority
error
Inoperable
CM11 Cannot log in. Nothing is displayed or the
operation authority error.
Operation authority
error
Inoperable
CM20 Can operate only in the
range of resource group 20,
and the shared ports after
logging in.
Operable Operable Inoperable
* To use each resource group, the user must separately execute raidcom -login command. For details
about the raidcom -login command, see Command Control Interface Command Reference.
As shown in the table above, the relation among users, command devices
and operations of resource groups are the following.
• The range that can be operated by command device 0 (CM0) or Out-of-
Band is the shared range (AND) of resource groups that are allocated to
each user and all resource groups.
• The range that can be operated by command device 10 (CM10) is the
shared range (AND) of resource groups that are allocated to each user
and resource group 10 that the command devices are allocated.
Therefore, in the range of resource group 10 can be operated.
CCI functions
3-23
Command Control Interface User and Reference Guide