both Hosts), is unable to scan a port because the specified port is different
than the SLPR of the command device.
Figure 8-10 SLPR configuration on dual hosts
To operate SLPR#N, assign the command device. If HostB has a
command device for SLPR#N, the paircreate command is permitted.
However, the raidscan -p CL3-A command via HostA is unable to scan a
port because the specified port is different than the SLPR of the command
device. In this case, raidscan -p CL3-A command must be operated via
HostB.
Figure 8-11 Operation across SLPRs using two command devices on dual
hosts
To operate SLPR#N, share the command device. If HostB has a shared
command device for SLPR#N, the paircreate command is permitted. Also,
the raidscan -p CL3-A command (via HostA), is allowed to scan a port
8-20
Examples of using CCI commands
Command Control Interface User and Reference Guide
To Next Page
Loading...
