Hitachi VSP F1500 - Page 355

raidcom delete external_grp
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2EE8 FFFB An internal error occurred.
Call Hitachi Data Systems customer support.
Get Command
Status
Async 2EFF 41FF An internal error occurred.
Call Hitachi Data Systems customer support.
Table 9-13 SSB codes returned by raidcom check_ext_storage path
raidcom check_ext_storage path
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 4500 The path group is not in the enabled range.
CMDRJE Executing 2E00 8400 The value of the port is not enabled.
CMDRJE Executing 2E02 8403 The specified virtual port number is out of range.
Get Command
Status
Async 2E10 4301 The specified external volume has already
disconnected the path, or is in the process of
checking path.
CMDRJE Executing 2E10 8404 The iSCSI virtual port mode for the specified port
is disabled.
Get Command
Status
Async 2E11 001B The target LDEV is blocked.
Get Command
Status
Async 2E11 4000 The path for the specified external path is in the
state of disconnected.
Get Command
Status
Async 2E11 4302 All the paths for the specified external path are
blocked.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2E20 4100 There is no specified external volume.
Get Command
Status
CMDRJE
Async/
Executing
2E20 4300 There is no specified path.
CMDRJE Executing 2E20 4400 WWN is not registered.
CMDRJE Executing 2E20 4500 This command cannot be operated due to one of
the following reasons:
• There is no path group.
• external_wwn is not defined.
CMDRJE Executing 2E20 8401 The specified virtual port is not defined.
Troubleshooting
9-31
Command Control Interface User and Reference Guide